Weidmüller FBCON DP CG 1WAY 8564340000 pasivní box senzor/aktor standardní rozdělovač PROFIBUS-DP s ukončením sběrnice 1

The FBCon DP fieldbus distributors are used to couple 1 to 8 actuators, sensors or remote I/Os to a PROFIBUS network.
The branches (T-pieces) connect the individual bus components to the bus cable. The length of the branch cable depends on the transmission rate and should be as short as possible.
The total of all branch lengths for transmission rates up to 1.5 MBaud may not exceed 6.6 m.


The trunk line is run over EMC cable glands into an aluminium / stainless steel housing and connected using tension-clamp terminals.
The branch line to the device is connected using a B-coded M12 socket or an EMC cable gland.


Terminating resistors must be wired onto the start and end of the PROFIBUS-DP network. The Terminator modules can take care of this task.
The 24 V DC power supply is introduced via the right-hand cable gland. The housing features a pressure-compensation mechanism that counters the effects of climatic fluctuations.
The guidelines issued by the PROFIBUS user organisation must be observed during installation.


The distributors have the following characteristics:Tension-clamp connection systemEMC cable glandM12 plug-in connectorsExternal earthing contactInterruption-free bus operationPressure-equalising element IP 66 protection classStainless steel versionsPROFIBUS-DP compatible